DEIF AGC 3X 4198000234E AUTOMATIC GENSET CONTROLLER

1   DEIF AGC 3X 4198000234E AUTOMATIC GENSET CONTROLLER

Shifts the first line displaying in the setup menus. Push two seconds to switch to master display in case

more than one display is connected.

2. Moves the cursor left for manoeuvring in the menus.

3. Inreases the value of the selected setpoint (in the setup menu). In the daily use display, this button func

tion is used for scrolling the second line displaying of generator values.

4. Selects the underscored entry in the fourth line of the display.

5. Moves the cursor right for manoeuvring in the menus.

6. Decreases the value of the selected setpoint (in the setup menu). In the daily use display, this button

function is used for scrolling the second line displaying of generator values.

7. Changes the menu line (line 4) in the display to mode selection.

8. Jumps one step backwards in the menu (to previous display or to the entry window).

9. Shifts the display three lower lines to show the event and alarm list. The list holds 150 events. These

events are deleted when the AGC is switched off.

10. Manual activation of close breaker and open breaker sequence if "SEMI-AUTO" is selected.

11. Manual activation of close breaker and open breaker sequence if "SEMI-AUTO" is selected.

12. Stop of the genset if "SEMI-AUTO" or "MANUAL" is selected.

13. Start of the genset if "SEMI-AUTO" or "MANUAL" is selected.

14. Enters a specific menu number selection. All settings have a specific number attached to them. The

JUMP button enables the user to select and display any setting without having to navigate through the

menus (see later).

15. Shifts the display three lower lines to show the alarm list

The display unit holds 10 LED functions. The colour is green or red or a combination in different situations.

The display LEDs are indicating as follows

LED indicates that the auxiliary supply is switched on.

2. LED indicates that the unit is OK.

3. LED fixed light indicates that an alarm is enabled but inhibited. Please refer to Help in the PC utility soft

ware for description of inhibit settings.

4. LED indicates that auto mode is selected.

5. LED is green if the mains is present and OK. LED is red at a mains failure. LED is flashing green when

the mains returns during the "mains OK delay" time.

6. LED indicates that the mains breaker is closed.

7. LED indicates that the generator breaker is closed.

8. LED green light indicates that the voltage/frequency is present and OK.

9. LED indicates that the generator is running.

10. LED flashing indicates that unacknowledged alarms are present. LED fixed light indicates that ALL alarms

are acknowledged, but some are still present