Hot/wet extractive system ACF5000

The benchmark in FTIR CEMS

ACF5000 can measure up to 15 components simultaneously including water soluble components to accurately monitor the composition of exhaust gases.

• Longest certified maintenance interval with 12 months, issued by MCERTS in the UK

• Internal validation unit for QAL3 checks without the need for test gases

• Lowest maintenance costs

• High resolution FTIR with long-life optical components

• Pre-engineered based on > 25 years of experiences

• Internal validation unit – no need for bottled test gas for regular zero and span checks

ABB Ability^TM – Maintenance made easy with scalable digital solutions

• Dynamic QR Codes for easy transfer of all relevant diagnostic information for faster troubleshooting and repair

• Remote Assistance solution for expert on-demand service providing remote diagnostic and assistance for the analyzers

• Condition Monitoring provides scheduled remote product health checks and generates reliable early warnings for recommended maintenance actions

• Genix Datalyzer is cloud based analyzer fleet health monitoring solution

• Overview

  ABB’s new ACF5000 is the specialist for emission and process monitoring from the pioneers in FTIR CEMS. It is available in the 4th generation. Since introduction in 1993, ABB has sold more than 2000 units. The standard system design combines the advantages of a FTIR spectrometer, flame ionization (FID) technology and oxygen measurement. The high resolution FTIR spectrometer provides selective measurement of infrared active gas molecules with high sensitivity and stability.  
  
  The multi-component analyzer system ACF5000 offers:

• Simultaneous measurement of up to 15 gas components including all relevant pollutants

• Proven hot/wet extractive measurement

• Powerful FTIR technology for TOC

• Complete system with a compact and modular design
  − Internal references − allow on-going system validation
  − Lowest detection limits − suitable to monitor smallest emission limit values

• One single sample inlet for all sample gases with a unique air-driven aspirator pump

• Low cost of ownership

• Communication, control and maintenance via PROFIBUS, Modbus, TCP and Ethernet (OPC)