ABBconverter for standard signals

Specification Design for field housing unit (aluminum/stainless steel) Material / IP rating IP 65 aluminum or stainless steel housing unit Surface Aluminum housing, painted with dual component coating, lower section, black, RAL 9005, screw-on cover, Pantone 420, stainless steel housing unit, electrolytically polished Mounting Wall or 2 in pipe mounting With stainless steel mounting bracket (accessory) Electrical connection 2-pole screw terminal for 2.5 mm2 (14 AWG) in the housing, screw connection NPT ½ in for the cable entry. For ATEX ‘intrinsically safe’: Threaded hole NPT ½ in for the cable entry For ATEX ‘Ex d’: M20 × 1.5 threaded hole for cable entry at FM/CSA (Cable gland with Ex d approval available as an accessory on request) Pneumatic connection ¼ in NPT threaded hole for supply air and output Weight 0.62 kg (1.37 lb) with aluminum housing unit 1.20 kg (2.65 lb) for stainless steel housings. Dimensions Refer to Design for aluminum or stainless steel field mount housing on page 11. Accessories ‘Ex d’ cable gland Brass, with M20 × 1.5 thread Stainless steel mounting bracket for wall mounting or 2 in pipe mounting For aluminum or stainless steel field housing unit Material for block mounting Connection block for 4 signal converters, End panel with central supply air connection ⅜ NPT, dummy panel

Dimensions Design for control room housing unit for rail mounting Dimensions in mm (in)

Design for aluminum or stainless steel field mount housing For wall mounting or pipe mounting Dimensions in mm (in)