ADLINK CPCI-6910AM-M1G 6U Dual Core Xeon CompactPCI Universal SBC

ADLINK CPCI-6910AM-M1G 6U Dual Core Xeon CompactPCI Universal SBC

Product Introduction / Overview

The ADLINK CPCI-6910AM-M1G is an industrial-grade, high-performance 6U CompactPCI Single Board Computer (SBC) powered by an Intel Dual-Core Xeon processor. 

Built for mission-critical automation, defense systems, telecommunications, and heavy industrial processing, the board provides multi-threaded processing power coupled with robust thermal management and extensive front/rear I/O connectivity.

Featuring universal system/peripheral slot compatibility, the CPCI-6910 series enables dual-system control capabilities across standard PICMG 2.0 backplanes while maintaining shock and vibration resistance required in extreme environments.

Technical Table

Environmental Tolerance Conditions

Operating Temperature: 0°C to +55°C (Standard Forced Air Cooling) / -20°C to +70°C (Extended Temp / Rugged Variant)

Storage Temperature: -40°C to +85°C

Relative Humidity: 5% to 95% at 40°C (Non-condensing)

Operating Vibration: 5 Hz to 500 Hz, 2.0 Grms (random, 3 axes)

Shock Resistance: 15 G peak acceleration, 11 ms duration (half-sine wave)

Operating Instructions

Pre-Installation Alignment: Inspect the backplane J1–J5 pin headers on the 6U rack to ensure no bent pins or debris exist before mounting.

Card Insertion: Slide the CPCI-6910AM-M1G into the designated system master or peripheral slot along the guide rails.

Ejector Handle Lock: Firmly press the top and bottom red-button ejector handles inward until the board fully seats into the backplane connectors. Tighten the retaining screws.

BIOS Setup: Access the system BIOS by pressing DEL or F2 at boot up to configure boot priority (CompactFlash, PMC storage, or PXE Network Boot).

Fault Diagnosis

Related Models of the Same Series

CPCI-6910/DCX20/M2G: Dual-Core Xeon variant equipped with 2 GB onboard DDR2 ECC memory.

CPCI-6910/LV14/M1G: Single/Low-Voltage Intel Pentium M / Xeon option for lower power dissipation setups.

cPCI-R6910: Corresponding 6U Rear Transition Module (RTM) for rear cabling routing.

Storage Conditions

To prevent signal degradation or ESD damage during long-term storage:

Store in an ESD-shielded anti-static bag with desiccant packs.

Maintain ambient storage temperatures between -40°C and +85°C.

Avoid areas exposed to direct corrosive gases, high humidity (>95%), or excessive atmospheric condensation.