OMRON F150-C10E-2 Vision Controller

Press the SHIFT+SET or SHIFT+RESET Keys to maintain the status of the

bit after the key is released. In this case, the force-set status is indicated by

an “S” and the force-reset status is indicated by an “R.”

To return the bit to its original status, press the NOT key or perform the Clear

Force Set/Reset operation. (Refer to 3-3-16 Clear Force Set/Reset for de

tails.) Forced status will also be cleared when the ID Controller’s operating

mode is changed (unless SR 25211 is ON, in which case forced status will

not be cleared when changing from PROGRAM to MONITOR mode) or

when operation stops as the result of an error or power interruption

Clear Force Set/Reset

This operation is used to restore the status of all bits which have been force

set or reset. It is possible in MONITOR or PROGRAM mode only.

RUN MONITOR PROGRAM

1. Bring up the initial display.

2. Press the SET and then the RESET Key. A confirmation message will ap

Note If you mistakenly press the wrong key, press CLR and start again

from the beginning.

3. Press the NOT Key to clear the force-set/reset status of bits in all data areas.

Note Forced status will also be cleared when the ID Controller’s operating mode is

changed (unless SR 25211 is ON, in which case forced status will not be cleared

when changing from PROGRAM to MONITOR mode) or when operation stops

as the result of an error or power interruption.

3-3-17 Binary Monitor

1. 2. 3...

This operation is used to monitor the ON/OFF status of any word’s 16 bits. It

is possible in any mode.

RUN MONITOR PROGRAM

1. Monitor the status of the desired word according to the procedure described

in 3-3-12 Bit, Digit, Word Monitor. The desired word should be leftmost on

the display if 2 or more words are being monitored.

2. Press the SHIFT and then the MONTR Key to begin binary monitoring. The

ON/OFF status of the selected word’s 16 bits will be shown along the bottom

of the display. A 1 indicates a bit is on, and a 0 indicates it is off