Shinkawa LCU-37 Monitoring module



Shinkawa LCU-37 Local Control Unit is a machinery protection and condition monitoring module engineered by Shinkawa Electric. Designed for integration into Shinkawa's VM series vibration monitoring systems, the LCU-37 receives, conditions, and processes analog signals from non-contact eddy-current proximity probes, velocity transducers, and accelerometers. It acts as a dedicated monitoring unit for continuous protection of critical rotating assets such as steam turbines, gas turbines, centrifugal compressors, and heavy industrial pumps.

Technical Parameter List

Core Advantages & Product Features

High-Precision Signal Processing: Processes high-frequency vibration and micro-inch displacement signals with minimal drift and fast response times.

API 670 Compliant Architecture: Designed to meet international rotating machinery protection guidelines for critical plant assets.

Dual-Stage Alarm Logic: Independent Alert and Danger trip thresholds prevent false trips while ensuring rapid machine shutdown during catastrophic events.

Continuous Sensor Health Monitoring: Built-in OK circuit continuously checks transducer cable integrity and power levels, flagging sensor wire breaks or driver failures instantly.

Industrial Noise Rejection: Shielded circuitry and passive filtering protect against high electromagnetic interference (EMI) typical of power generation environments.

Model Classification

LCU-37: Core local control / signal processing unit module.

LCU-44B-06: Advanced local control unit variant for high-density multi-channel racks.

VK Series (VK-202A / VK-452A): Non-contact eddy-current displacement sensors used in conjunction with LCU modules.

VM-5 / VM-7 Series: System backplane racks and chassis housing LCU control cards.

Environmental Tolerance Conditions

Operating Temperature: 0°C to +65°C (32°F to 149°F)

Storage Temperature: -30°C to +85°C (-22°F to 185°F)

Relative Humidity: 5% to 95% RH (Non-condensing)

Vibration Resistance: Conforms to IEC 60068-2-6 standard for industrial control cabinets

Protection Rating: IP20 (Requires mounting inside an IP54 or higher control enclosure)

Installation Method

Power Down: Disconnect power from the main VM rack system before card insertion or removal.

Rack Alignment: Slide the LCU-37 module along the designated slot guides in the VM chassis until the rear multi-pin connector fully seats into the backplane.

Card Retention: Tighten top and bottom front-panel thumbscrews to lock the card against cabinet vibration.

Sensor Cabling: Route transducer wiring through dedicated shielded cable channels, grounding the cable shield braid at the rack chassis ground terminal only.

Operating Instructions

Initial Zero & Span Adjustments: Calibrate sensor inputs using standard calibration procedures after replacing transducers or cable runs.

Threshold Configuration: Set Alert and Danger alarm setpoints according to equipment OEM vibration tolerance limits.

System Status Monitoring: Routinely verify front-panel LED indicators (OK / ALERT / DANGER) during daily operator inspection rounds.