ADLINK NuPRO-595 Series Full-Size PICMG 1.0 SBC

ADLINK NuPRO-595 Series Full-Size PICMG 1.0 SBC

Product Introduction / Overview

The ADLINK NuPRO-595 Series is a classic industrial-grade, full-size PICMG 1.0 Single Board Computer (SBC) designed for legacy industrial automation, test and measurement systems, workstation upgrades, and embedded controlling environments.

Featuring a Socket 370 processor interface (supporting Intel Pentium III and Celeron processors), the NuPRO-595 routes signals through a passive backplane architecture via ISA and PCI golden finger connectors.

 It provides high operational stability, integrated display controller capabilities, and comprehensive serial/parallel I/O interfaces built to withstand harsh, long-term industrial deployment.

Technical Table

Technical Table

Environmental Tolerance Conditions

Operating Temperature: 0°C to +60°C (32°F to 140°F)

Storage Temperature: -20°C to +80°C (-4°F to 176°F)

Relative Humidity: 5% to 95% at 40°C (Non-condensing)

Vibration Resistance: 0.5 Grms, 5 to 500 Hz (Random, operating)

Shock Resistance: 10 G peak acceleration (11 ms duration, operating)

Operating Instructions

Backplane Insertion: Turn off main system power. Align the card edge gold fingers with the designated master PICMG 1.0 slot on the passive backplane, then press down firmly until fully seated.

CPU and Fan Installation: Secure a compatible Socket 370 processor and mount a CPU cooler fan. Connect the 3-pin CPU fan cable to the onboard CPU_FAN header.

Jumper Configuration: Set onboard jumpers (e.g., FSB frequency selection, CMOS clear, RS-232/422/485 serial mode) according to the system documentation before initial boot-up.

BIOS Setup: Press DEL during POST to access the Award BIOS utility for boot sequence setup, IDE configuration, and memory address reservations.

Fault Diagnosis

Related Models of the Same Series

NuPRO-595V: Base model featuring integrated AGP VGA and single 10/100M Fast Ethernet LAN port.

NuPRO-595LV: Extended variant equipped with integrated LCD panel support (TTL/LVDS) and single LAN.

NuPRO-595DV: High-density networking version equipped with Dual 10/100M LAN controllers and integrated VGA display.

Storage Conditions

To prevent physical or electronic degradation during extended storage:

Store the board inside an ESD-safe anti-static bag with desiccant gel packs.

Maintain ambient temperatures between -20°C and +80°C.

Keep storage environments clean, dry, and shielded from atmospheric condensation, chemical fumes, and high magnetic fields.