Abaco VME-3113B Scanning 12-bit Analog-to-Digital Converter with Built-in-Test

Abaco VME-3113B Scanning 12-bit Analog-to-Digital Converter with Built-in-Test

Abaco VME-3113B Scanning 12-bit Analog-to-Digital Converter with Built-in-Test

Overview

VME-3113B, Scanning 12-bit Analog-to-Digital Converter with Built-in-Test

Powers up in autoscanning mode-no software initialization required

Continually digitizes all input channels and stores the results in dedicated channel dual-port registers (autoscanning mode)

64 differential or single-ended inputs

Supports real-time and off-line Built-in-Test

Specifications

Channel Voltage Ranges

0-10V, ±5V, ±10V

Channels

64

Form Factor

VME

Function

12-bit ADC

Throughput

33 kHz

ABB C1627

MVME162-043 industrial system card module

PFTL201C 50KN

ABB TU845 Redundant I/O base, AI845,DP840, vertically installed

GE 336A3435ALGO1 GE CABLE

MOTOROLA  MVME162-032

FOXBORO P0400HE

IS200TRPGH3B series spare parts industrial system

MVME2604-1361 Industrial System card module

Safety specifications are generally applicable to control system handling. Instructions and warnings related to a specific subject or operation of the product.

The following norms must be strictly observed:

 must strictly comply with the technical specifications and typical applications of the product system

 Personnel training: Only trained personnel shall install, operate, maintain or repair the product system. must

Provide guidance and explanation of the situation in danger areas to these personnel.

 Unauthorized changes: Changes or structural changes to the product system may not be made.

 Maintenance responsibility: Must ensure that the product system is used only under appropriate conditions and in full fitness for use.

 Working environment: The user must meet the specified environmental conditions:

Safety regulation

The following safety provisions of EN 50110-1 shall be fully complied with when handling product systems (maintenance) :

1 Disconnect completely.

2 Secure to prevent reconnection.

3 Verify that the installation is complete.

4 Ground and short-circuit the device.

Warning: Only qualified maintenance personnel can remove and insert the module. In order to ensure the personal safety of the operator, before each pulling out or inserting, you must

Disconnect the power supply and ensure that there is no voltage on all terminals at the back, and the product is effectively grounded with the ground screw at the back.