Abaco Vme-4132 VME Analog I/O Output board

Abaco Vme-4132 VME Analog I/O Output board

Vme-4132 VME Analog I/O Output board
Overview
VME-4132 32-channel analog output board, built-in test
Front panel self-check LED
0.1Ω output impedance
Built-in on-board testing
32 analog output channels
On-board +/- 15V DC-DC conversion
Specification
Channel voltage range
0-5V, 0-10V, ±2.5V, ±5V, ±10V
Channel
32
Overall dimensions
VME
Function
12-bit DAC
Throughput
3.4 milliseconds

GE DS200SHCAG1B CARD SHUNT CONNECT

DS200TCCAG2A series spare parts

IC752WBB252 series spare parts industrial system

METSO IOP302

GE 173C8443AKG04 GE HEAT SINK

Bus control module 7EX290.50-1

ABB   3BHB009182P0001

IS215VCMIH2B series spare parts industrial system

GE   DS200DMCBG1AKG

GE DS3815PIOA1B1A1

ABB 086329-003

BRC100, BRC200, BRC300, BRC400, BRC410, all brand-new ABB Bailey models

GE 531X305NTBANG1

Safety specifications are generally applicable to control system handling. Instructions and warnings related to a specific subject or operation of the product.

The following norms must be strictly observed:

 must strictly comply with the technical specifications and typical applications of the product system

 Personnel training: Only trained personnel shall install, operate, maintain or repair the product system. must

Provide guidance and explanation of the situation in danger areas to these personnel.

 Unauthorized changes: Changes or structural changes to the product system may not be made.

 Maintenance responsibility: Must ensure that the product system is used only under appropriate conditions and in full fitness for use.

 Working environment: The user must meet the specified environmental conditions:

Safety regulation

The following safety provisions of EN 50110-1 shall be fully complied with when handling product systems (maintenance) :

1 Disconnect completely.

2 Secure to prevent reconnection.

3 Verify that the installation is complete.

4 Ground and short-circuit the device.

Warning: Only qualified maintenance personnel can remove and insert the module. In order to ensure the personal safety of the operator, before each pulling out or inserting, you must

Disconnect the power supply and ensure that there is no voltage on all terminals at the back, and the product is effectively grounded with the ground screw at the back.