IBA ibaPADU-4-AI-U Compact Measurement Modules

IBA  ibaPADU-4-AI-U   Compact Measurement Modules

Introduction

EtherNet/IP (EtherNet Industrial Protocol) is a real-time Ethernet which is mainly used in

automation technology.

The EtherNet/IP bus monitor ibaBM-ENetIP is a device for acquiring the cyclical data

exchange between EtherNet/IP scanner (master) and adapters (slaves). The device can

be integrated into an existing EtherNet/IP network with one or more EtherNet/IP scan

ners (master).

The ibaBM-ENetIP bus monitor can be operated in an EtherNet/IP network without inter

ferences using the TAP interface (Ethernet). The device works as sniffer, i.e. it listens to

the cyclic data exchange of the IO data (implicit messaging) between EtherNet/IP scan

ner (master) and adapters (slaves).

The entire communication via the TAP interface is being mirrored to a monitor port and

can be recorded using an external network analysis tool.

On the optical-fiber side, ibaBM-ENetIP works with the ibaNet protocol 32Mbit Flex. With

this protocol, measuring and configuration data are transferred via a bidirectional fiber

optic connection. The sampling rate and the data formats can be configured flexibly.

Overview of the most important characteristic values:

❑ TAP interface for sniffer function

❑ Monitor interface for connecting a network analysis tool

❑ Data acquisition with ibaPDA

❑ Simple configuration and measurement via bidirectional FO connection with ibaNet

protocol 32Mbit Flex

❑ Flexible configuration of sampling rate and data formats with 32Mbit Flex

Scope of delivery

After having unpacked the delivery, please check if it is complete and intact.

The following components are included in delivery:

❑ ibaBM-ENetIP device

Safety instructions

Designated use

The device is an electrical equipment. It may only be used for the following applications:

❑ Measurement data acquisition and measurement data analysis

❑ Automation of industrial plants

❑ Applications of iba software products (e.g ibaPDA) and iba hardware products

The device may only be used as defined in the "Technical Data" chapter.

Mounting

1. Insert the DIN rail clip on the rear side of the device on top in the DIN rail, press the

device down/back and let the DIN rail lock.

2. If there is the provision in the plant that the device has to be grounded, then connect

the device to the ground (shield connector X29).

3. Once fixed, connect the 24 V DC power supply with the right polarity.

4. Connect FO cable to the ibaPDA system (bidirectional).

5. Connect the Ethernet cable

Dismounting

1. First of all, disconnect all connections that exist to the device.

2. Grasp the device with one hand firmly on the top side. For the device later lies firmly

in your hands and does not fall to the floor, please press the device slightly down.

3. With the other hand, grasp the device on the bottom and pull it to the front/top. The

device will get detached from the DIN rail.