OMRON F500-VS F500-S1

OMRON  F500-VS   F500-S1

The different portions of the display are given in the following table, using the

data in the above example display.

Displayed data

Meaning

The date that the error was generated.

05

10:14:20

The time that an error was generated. If the Memory

Cassette used is not equipped with a clock function, the

date and time will be displayed as all zeros.

NO1

The error log data number. Here, N30 is the most recent,

and N01 is the oldest error.

RD

The command that generated the error. In this case, it is

IDRD. The following displays will appear for ID

communications instructions:

RD: IDRD

AR: IDAR

MD: IDMD

CA: IDCA

WT: IDWT

AW: IDAW

COM.DC E

The error message. Refer to 1-1-3 ID Controller Functions

for the meaning of error messages.

3. Press the Down Cursor Key shifts the display from the current position to the

next most recent error.

Pressing the Up Cursor Key shifts the display from the current position to the

oldest error.

Pressing the Up Cursor Key with N01 data displayed, displays N30 data,

and pressing the Down Cursor Key with N30 data displayed, displays N01

data.

4. Press the Clear Key to leave the ID error log display, and returns to the initial

display.

The following display will appear when there are no ID error logs.

The following display will appear while reading the ID communications error log

and the display has been moved past the last recorded error

ID errors are displayed by pressing the shift key and the monitor key in that order.

Displaying ID Error Statistics Log

1. 2. 3...

1. Press the Shift Key and the Monitor Key to display ID error menu

The different portions of the display are given in the following table, using the

data in the above example display.

Press the Down Cursor Key to display the number of times an error was gen

erated for the next error code number

Pressing the Up Cursor Key displays the number of times an error was gen

erated for the previous error code number.

4. Press the Clear Key to quit the ID Error Statistics Log display and return to

the initial screen.

This operation is used to clear all or part of the Program Memory and any data

areas that are not read-only. This operation is possible in PROGRAM mode only.

The following procedure is used to clear memory completely.

1. 2. 3...

1. Bring up the initial display by pressing the CLR key repeatedly.

2. Press the SET, NOT, and then the RESET Key to begin the operation

It is possible to retain the data in specified areas or part of the Program

Memory. To retain the data in the HR, TC, or DM Areas, press the appropri

ate key after pressing SET, NOT, and RESET. Any data area that still ap

pears on the display will be cleared when the MONTR Key is pressed.

The HR Key is used to specify both the AR and HR Areas, the CNT Key is

used to specify the entire timer/counter area, and the DM Key is used to

specify the DM Area.

It is also possible to retain a portion of the Program Memory from the first

memory address to a specified address. After designating the data areas to

be retained, specify the first Program Memory address to be cleared. For ex

ample, input 030 to leave addresses 000 to 029 untouched, but to clear ad

dresses from 030 to the end of Program Memory.

1. 2. 3...

As an example, follow the procedure below to retain the timer/counter area and

Program Memory addresses 000 through 122:

1. Bring up the initial display.

2. Press the SET, NOT, and then the RESET Key to begin the operation.

3. Press the CNT Key to remove the timer/counter area from the data areas

shown on the display.