REXRTOHIndraDrive Control Sections CSB02, CSE02, CSH02, CDB02

regulations, the manufacturer of the machine or installation must take

measures to avoid injuries caused by burns in the final application.

These measures can be, for example: Warnings at the machine or in‐

stallation, guards (shieldings or barriers) or safety instructions in the ap‐

plication documentation.

3.3.6 Protection during handling and mounting

Risk of injury by improper handling! Injury by crushing, shearing, cutting, hit‐

ting!

● Observe the relevant statutory regulations of accident prevention.

● Use suitable equipment for mounting and transport.

● Avoid jamming and crushing by appropriate measures.

● Always use suitable tools. Use special tools if specified.

● Use lifting equipment and tools in the correct manner.

● Use suitable protective equipment (hard hat, safety goggles, safety

shoes, safety gloves, for example).

● Do not stand under hanging loads.

● Immediately clean up any spilled liquids from the floor due to the risk of

falling!

3.3.7 Battery safety

Batteries consist of active chemicals in a solid housing. Therefore, improper

handling can cause injury or property damage.

Risk of injury by improper handling!

● Do not attempt to reactivate low batteries by heating or other methods

(risk of explosion and cauterization).

● Do not attempt to recharge the batteries as this may cause leakage or

explosion.

● Do not throw batteries into open flames.

● Do not dismantle batteries.

● When replacing the battery/batteries, do not damage the electrical parts

installed in the devices.

● Only use the battery types specified for the product.

Environmental protection and disposal! The batteries contained in

the product are considered dangerous goods during land, air, and

sea transport (risk of explosion) in the sense of the legal regula‐

tions. Dispose of used batteries separately from other waste. Ob‐

serve the national regulations of your country.

3.3.8 Protection against pressurized systems

According to the information given in the Project Planning Manuals, motors

and components cooled with liquids and compressed air can be partially sup‐

plied with externally fed, pressurized media, such as compressed air, hy‐

draulics oil, cooling liquids and cooling lubricants. Improper handling of the

connected supply systems, supply lines or connections can cause injuries or

property damage.

Risk of injury by improper handling of pressurized lines!

● Do not attempt to disconnect, open or cut pressurized lines (risk of ex‐

plosion).

● Observe the respective manufacturer's operating instructions.

● Before dismounting lines, relieve pressure and empty medium.

● Use suitable protective equipment (safety goggles, safety shoes, safety

gloves, for example).

● Immediately clean up any spilled liquids from the floor due to the risk of

falling!

Environmental protection and disposal! The agents (e.g., fluids)

used to operate the product might not be environmentally friendly.

Dispose of agents harmful to the environment separately from

other waste. Observe the national regulations of your country.

DOK-INDRV*-CXX02******-PR03-EN-P Bosch Rexroth AG 23/143

IndraDrive Control Sections CSB02, CSE02, CSH02, CDB02

S

Explanation of signal words and the Safety alert symbol

The Safety Instructions in the available application documentation contain

specific signal words (DANGER, WARNING, CAUTION or NOTICE) and,

where required, a safety alert symbol (in accordance with

ANSI Z535.6-2011).

The signal word is meant to draw the reader's attention to the safety instruc‐

tion and identifies the hazard severity.

The safety alert symbol (a triangle with an exclamation point), which pre‐

cedes the signal words DANGER, WARNING and CAUTION, is used to alert

the reader to personal injury hazards.

DANGER 

In case of non-compliance with this safety instruction, death or serious injury

will occur.

WARNING 

In case of non-compliance with this safety instruction, death or serious injury

could occur.

CAUTION 

In case of non-compliance with this safety instruction, minor or moderate in‐

jury could occur.

NOTICE 

In case of non-compliance with this safety instruction, property damage could

occur.