parkerVM600 MPC4 machinery protection card

interchangeability.

ABE04x VM600 system racks : Refer to corresponding data sheet

ABE056 VM600 slimline rack : Refer to corresponding data sheet

AMC8 and IOC8T VM600 analog monitoring card pair : Refer to corresponding data sheet

CPUM and IOCN VM600 modular CPU card and

input/output card.

Note: With a front-panel display and support 

for Modbus RTU/TCP or PROFINET.

: Refer to corresponding data sheet

CPUR and IOCR VM600 rack controller and communications 

interface card pair.

Note: With rack controller redundancy and 

support for Modbus RTU/TCP.

: Refer to corresponding data sheet

CPUR2 and IOCR2 VM600 rack controller and communications 

interface card pair.

Note: With mathematical processing of 

fieldbus data and support for Modbus TCP 

and PROFIBUS.

: Refer to corresponding data sheet

IOC4T VM600 input/output card (for the MPC4) : Refer to corresponding data sheets

IRC4 VM600 intelligent relay card : Refer to corresponding data sheet

MPC4G2 and IOC4G2 VM600 machinery protection card pair : Refer to corresponding data sheet

RLC16 VM600 relay card : Refer to corresponding data sheet

RLC16G2 VM600 relay card : Refer to corresponding data sheet

XMx16 and XIO16T VM600 condition monitoring card pairs : Refer to corresponding data sheet

Meggitt (Meggitt PLC) is a leading international engineering company, headquartered in England, that designs and delivers high-performance 

components and subsystems for aerospace, defence and selected energy markets. Meggitt comprises four customer-aligned divisions: 

Airframe Systems, Engine Systems, Energy & Equipment and Services & Support.

The Energy & Equipment division includes the Energy Sensing and Controls product group that specialises in sensing and monitoring solutions for a 

broad range of energy infrastructure, and control valves for industrial gas turbines, primarily for the Power Generation, Oil & Gas and Services markets. 

Energy & Equipment is headquartered in Switzerland (Meggitt SA) and incorporates the Vibro-Meter® product line, which has over 65 years of sensor 

and systems expertise and is trusted by original equipment manufacturers (OEMs) globally.

All information in this document, such as descriptions, specifications, drawings, recommendations and other statements, is believed to be 

reliable and is stated in good faith as being approximately correct, but is not binding on Meggitt (Meggitt SA) unless expressly agreed in 

writing. Before acquiring and/or using this product, you must evaluate it and determine if it is suitable for your intended application. You 

should also check our website at www.meggittsensing.com/energy for any updates to data sheets, certificates, product drawings, user 

manuals, service bulletins and/or other instructions affecting the product.

Unless otherwise expressly agreed in writing with Meggitt SA, you assume all risks and liability associated with use of the product. Any 

recommendations and advice given without charge, whilst given in good faith, are not binding on Meggitt SA. Meggitt (Meggitt SA) takes 

no responsibility for any statements related to the product which are not contained in a current Meggitt SA publication, nor for any 

statements contained in extracts, summaries, translations or any other documents not authored and produced by Meggitt SA.

The certifications and warranties applicable to the products supplied by Meggitt SA are valid only for new products purchased directly from 

Meggitt SA or from an authorised distributor of Meggitt SA.

In this publication, a dot (.) is used as the decimal separator and thousands are separated by thin spaces. Example: 12345.67890.

Copyright© 2019 Meggitt SA. All rights reserved. The information contained in this document is subject to change without prior notice.