GEDatasheet MVME6100 Series VME Single-Board Computer

SPECIFICATIONS

Microprocessor: MPC7457

Clock Frequency: 1.267 GHz

On-chip L1 Cache (I/D): 32K/32K

On-chip L2 Cache: 512K

L3 Cache: 2MB

Type: Double data rate (DDR) ECC SDRAM

Speed: DDR266 (133 MHz)

Capacity: Up to 2GB, all memory on board

Configurations: Two banks, 512MB or 1GB configurations 

available at release

Type: EEPROM, on-board programmable

Capacity: 128MB soldered Flash in two banks of 

64MB each

Write Protection: Flash is write protectable via jumper

Capacity: 32KB (4KB available for users)

Cell Storage Life: 50 years at 55° C

Cell Capacity Life: 5 years at 100% duty cycle, 25° C

Removable Battery: Yes

Compliance: ANSI/VITA 1-1994 VME64 (IEEE STD 

1014), ANSI/VITA 1.1-1997 VME64 

Extensions, VITA 1.5-199x 2eSST

Controller: Tundra Tsi148

DTB Master: A16, A24, A32, A64; D08-D64, SCT, BLT, 

MBLT, 2eVME, 2eSST

DTB Slave: A16, A24, A32, A64; D08-D64, SCT, BLT, 

MBLT, 2eVME, 2eSST, UAT

Arbiter: RR/PRI

Interrupt

Handler/Generator:

IRQ 1-7/Any one of seven IRQs

System Controller: Yes, jumperable or auto detect

Location Monitor: Two, LMA32

Ethernet Interface

Asynchronous Serial Ports

Dual IEEE P1386.1 PCI Mezzanine Card Slots

PCI Expansion Connector

Counters/Timers

Board Size and Weight

Power Requirements

Mean Time Between Failure

178,403 hours, calculated using Bellcore Standard: Issue 6, Method 1, 

Case 3

IPMC Modules PMC Interface

SCSI Bus

Note: 16-bit SCSI operation precludes the use of some PMC slot 2 

signals.

Asynchronous Serial Ports

Synchronous Serial Ports

Controller: Ethernet controller integrated into host 

bridge; two Gigabit Ethernet interfaces

Interface Speed: 10/100/1000Mb/s

Connector: One routed to front panel RJ-45; one 

routed to front panel RJ-45 or optionally 

routed to P2 (10/100 routed to RJ-45 on 

MVME761 for IPMC mode, Gigabit routed 

to P2 for PMC mode)

Controller: ST16C554DCQ64

Number of Ports: Two, 16550 compatible

Configuration: EIA-574 DTE

Async Baud Rate, b/s

max.:

38.4K EIA-232, 115Kb/s raw

Connector: One routed to front panel RJ-45; one on 

planar for development use

Address/Data: A32/D32/D64, PMC PN1, PN2, PN3, PN4 

connectors

PCI Bus Clock: 33 MHz, 66 MHz or 100 MHz

Signaling: 3.3V, 5V tolerant

Power: +3.3V, +5V, ±12V

Module Types: Two single-wide or one double-wide, front 

panel or P2 I/O, PMC and PrPMC support

Address/Data: A32/D32/D64

PCI Bus Clock: 33/66 MHz

Signaling: 5V

Power: +3.3V, +5V, ±12V

Connector: 114-pin connector located on MVME6100 

planar, same location as on MVME5500 

planar

TOD Clock Device: ST (SGS-Thompson) M4T28

Real-Time

Timers/Counters:

Four, 32-bit programmable

Watchdog Timer: Time-out generates reset

Height: 233.4 mm (9.2 in.)

Depth: 160.0 mm (6.3 in.)

Front Panel Height: 261.8 mm (10.3 in.)

Width: 19.8 mm (0.8 in.)

Max. Component

Height:

14.8 mm (0.58 in.)

Weight: 425 g/15 oz. (Scanbe handles); 468 g/16.5 

oz. (IEEE handles)

(Not including power required by PMC or IPMC modules)

+5V ± 5%

MVME6100: 8.4 A typ., 10.2 A max.

MVME6100 with

MVME761:

9.2 A typ., 11.2 A max.

Address/Data: A32/D32/D64, PMC PN1, PN2, PN3, PN4 

connectors

PCI Bus Clock: 33 MHz

Signaling: 5V

Module Type: Basic, single-wide; P2 I/O

Controller: Symbios 53C895A

PCI Local Bus DMA: Yes, with PCI local bus burst

Asynchronous (8-bit

mode):

5.0MB/s

Ultra SCSI: 20.0MB/s (8-bit mode), 40.0MB/s (16-bit 

mode)

Controller: 16C550 UART; 85230/8536

Number of Ports: Two (IPMC761); three (IPMC712)

Configuration: EIA-574 DTE (IPMC761);

EIA-232 (IPMC712)

Async Baud Rate, b/s

max.:

38.4K EIA-232, 115Kb/s raw

Controller: 85230/8536

Number of Ports: Two (IPMC761); one (IPMC712)

Configuration: IPMC761: TTL to P2 (both ports), SIM 

configurable on MVME761;

IPMC712: EIA-232 to P2

Baud Rate, bps max.: 2.5MB sync, 38.4KB async

Oscillator Clock Rate

(PCLK):

10 MHz/5 MHz

Parallel Port Power Requirements

(Additional power load placed on MVME6100 with IPMC installed)

Transition Modules I/O Connectors

Board Size

All Modules Environmental Safety

All printed wiring boards (PWBs) are manufactured with a flammability 

rating of 94V-0 by UL recognized manufacturers.

Electromagnetic Compatibility (EMC)

Intended for use in systems meeting the following regulations:

Motorola Computer Group board products are tested in a 

representative system to the following standards, results pending:

Controller: PC97307

Configuration: 8-bit bi-directional, full IEEE 1284 support; 

Centronics compatible (minus EPP and 

ECP on MVME712M)

Modes: Master only

IPMC761 IPMC712

+5V: 0.5 A max. 0.5 A max.

+3.3V: 0.75 A max. 0.75 A max.

MVME761 MVME712M

Asynchronous Serial Ports: Two, DB-9 labeled as COM1 and COM2 Three, DB-25 labeled as Serial 1, Serial 2 and Serial 3

Synchronous Serial Ports: Two, HD-26 labeled as Serial 3 and Serial 4 (userconfigurable via installation of SIMs);

two 60-pin connectors on MVME761 planar for 

installation of two SIMs

One, DB-25 labeled as Serial 4

Parallel Port: HD-36, Centronics compatible D-36, Centronics compatible

Ethernet: 10BaseT or 100BaseTX, RJ-45 Not available

SCSI: 8- or 16-bit, 50- or 68-pin connector via P2 adapter 8-bit, standard SCSI D-50

Height: 233.4 mm (9.2 in.)

Depth: 80.0 mm (3.1 in.)

Front Panel Height: 261.8 mm (10.3 in.)

Front Panel Width: MVME761: 19.8 mm (0.8 in.)